Bush Hog 4815

Double tap to zoom

CONSTRUCTION FEATURES

Heavy structure on center section and wings.
Wing skids are 3/8” thick with an outside angle of 45 degrees to stop “ground dig-in” during turns.
All axle spindles are half shafts for quick and less costly maintenance.
Center section blades align closely with outside center tires to closely cut out the bottom of ditches.
Grease fittings and spring steel bushings are at axle pivot points for longer life.
Each cutting gearbox has a 3 inch output shaft with more and deeper splines than competitor models for maximum torque load capabilities.
All drivelines are EZ lube with grease points aligned and the cross bearing fitting is in the end cap.

SAFETY FEATURES

MODELS	4815
CUTTING WIDTH	15'
CUTTING HEIGHT	2″ -14″
CUTTING CAPACITY	4 1/2"
TRANSPORT WIDTH*	8' 2"
TRANSPORT HEIGHT**	7' 3"
TRANSPORT LENGTH***	15' 3"
APPROXIMATE WEIGHT (LB)	6,200
APPROXIMATE TONGUE WEIGHT (LB.)	2,700
MINIMUM TRACTOR PTO HP	70
HITCH	"PERMA-LEVEL" OR BALL HITCH
CENTER DECK	11GA OVER 7GA
WING DECKS	7GA
WING CUTTING ANGLES	22° DOWN AND 45° UP
WING LEVEL ADJUSTMENT	TURNBUCKLES
SIDEBANDS	1/4″ X 13 1/2″
TRANSFER GEARBOX (HP)	250
CUTTING GEARBOX (HP)	225
INPUT DRIVELINE	CATEGORY 6
CUTTING DRIVELINES	CATEGORY 5
BLADE HOLDER	7GA ROUND
BLADES	1/2″ X 4″
BLADE TIP SPEED (FPM)	16,268
AXLE SUSPENSION	SPRINGS @ EACH AXLE
CENTER & WING HYDRAULICS	3 HOSES STANDARD
SAFETY TOW CHAIN	STANDARD
DISTRIBUTION BAFFLES	OPTIONAL
PTO DRIVELINE SUPPORT	OPTIONAL